![]() MIDI Control Surfaces (Legacy Controllers) ![]() If an Asante network card is in your system, it can cause Ethernet controllers to go on/offline every few seconds, and you will not be able to maintain a reliable connection to the Control|24 or other Ethernet controller.įor more information on using control surfaces with Pro Tools, see the Control|24 Guide, Command|8 Guide, and the Getting Started and Pro Tools Reference guides in the Technical Document Library or your Pro Tools documentation folder.įor third-party devices such as the MoterMix, HUI, CS-10 or PC-1600, see the MIDI Control Surfaces Guide in the Technical Document Library: Asante network cards are not recommended for Pro Tools systems using Ethernet controllers such as Control|24.For more information, see the Command|8 Guide. Command|8 can be used in combination with non-MIDI control surfaces such as Control|24 with some limitations.Command|8 must be the only MIDI control surface enabled within Pro Tools.Multiple Command|8 units cannot be enabled simultaneously. Only one Command|8 can be used with a Pro Tools system.The built-in Digi 002 faders cannot be used to control any device other than that Digi 002.Pro Tools 6.0 and later no longer supports and will not install the Penny & Giles MM-16 and DC-16 Control Surface Personality Files.New MIDI control surface features are provided through the latest Control Surface Personality files installed with Pro Tools.D-Control and ProControl control surfaces are are not compatible with Pro Tools LE systems.Digidesign ProControl, FaderPack for ProControl and EditPack for ProControl are only compatible with TDM systems.Digidesign D-Control and D-Control Fader Packs are only compatible with Pro Tools|HD and Pro Tools|HD Accel systems.These are also available for download in the Support->Downloads->MIDI Control Surfaces section of the website. The Pro Tools 6.4.1 Installer CD contains an "unsupported" folder with the following control surface personality files: The following control surfaces were not tested with Pro Tools 6.4.1, and therefore are not officially supported. Edit Pack (serial number PT00601 or higher required).The following devices are qualified for use with Pro Tools MIX systems with Pro Tools 6.4.1 TDM software for Windows XP: With Pro Tools|24 MIX Systems with Pro Tools 6.4.1 for Windows XP ![]() Control Surfaces & MIDI Interfaces - MIX Systems with Pro Tools 6.4.1 for Windows XP ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |